Support Center

HOWTO: Socomec DIRIS A10 quick install guide

Last Updated: Dec 03, 2012 12:55PM CET
To follow this guide you will need:
  • 1 x DEXGate
  • 1 x DIRIS A-10
  • 1 x USB-RS485 addapter
  • 1 x Computer
  • 1 x Ethernet Cable
  1. Install the current transformers following the following diagram:
  2. Connect the orange usb cable to the 17 connector, the yellow cable to the 15 connector and the black cable to the 13 connector:
  3. Power up the meter
  4. Access to set up menu (pass code: 100)
  5. Select connection type and Configure current transformers factor
  6. Reset meter values
  7. Configure ModBus address
  8. Power up the DEXGate
  9. Connect the USB-RS485 cable to the DEXGate
  10. Connect the Ethernet cable to your computer and the ETH1 port of the DEXGate
  11. Access the web administration interface of the DEXGate (
  12. Login (the default username and password are admin/admin)
  13. Go to the "Bridge Configuration" section
  14. Edit the line:
    to look like this:
  15. where "10" indicates ModBus meter adress
  16. Save
  17. Restart the modbus bridge or the DEXGate
  18. You're done!

Contact Us

  • Post a Public Question
  • Email Us
  • Tel : +34 931 810 195
    Hours: 9am - 6pm CEST, Mon to Fri

    Check Public holidays here

seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found