Support Center

HOWTO: DEXGate Electrex Femto-D4 quick install guide

Last Updated: Aug 23, 2012 06:41PM CEST
To follow this guide you will need:
  • 1 x DEXGate
  • 1 x Femto D4
  • 1 x USB-RS485 addapter
  • 1 x Computer
  • 1 x Ethernet Cable
Installation:
  1. Install the current transformers following the following diagram:
    DEXCell DEXMA Electrex FemtoD4 connection scheme
  2. Connect the orange usb cable to the A connector, the yellow cable to the B connector and the black cable to the GROUND connector:
  3. Power up the meter
  4. Access to set up menu and configure ModBus address.
  5. Configure current transformers factor
  6. Reset meter values
  7. Power up the DEXGate
  8. Connect the USB-RS485 cable to the DEXGate
  9. Connect the Ethernet cable to your computer and the ETH1 port of the DEXGate
  10. Access the web administration interface of the DEXGate (http://172.16.0.1)
  11. Login (the default username and password are admin/admin)
  12. Go to the "Bridge Configuration" section
  13. Edit the line:
    devices.electrex-femto=
    to look like this:
    devices.electrex-femto=10
  14. It means that there is a Femto in ModBus adress 10.
  15. Save
  16. Restart the modbus bridge or the DEXGate
  17. You're done!

Contact Us

  • Post a Public Question
  • Email Us
  • Tel : +34 931 810 195
    Hours: 9am - 6pm CEST, Mon to Fri
    support@dexmatech.com

    Check Public holidays here

    Support
support@dexma.com
http://assets3.desk.com/
false
dexma
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete