Support Center

HOWTO: Carlo Gavazzi EM210 quick install guide on DEXGate2

Last Updated: Aug 08, 2017 03:45PM CEST
To follow this guide you will need:
  • 1 x DEXGate2
  • 1 x EM210
  • 1 x Computer or Mobile Phone with Wifi
Installation:
  1. Install the current transformers following the following diagram:
 ​​​
  1. Connect the 16th terminal of the EM210 to the A(+) terminal in DEXGate2, the 15th terminal of the EM210 to the B(-) terminal in DEXGate2 and the 17th terminal of the EM210 to the S terminal in DEXGate2
  2. Power up the meter
  3. Access to set up menu and configure ModBus address
  4. Configure current transformers factor
  5. Reset meter values
  6. Power up the DEXGate2
  7. Access the web administration interface of the DEXGate2 by connecting to its wifi access point and then enter (http://172.16.0.1)
  8. Login (the default username and password are admin/admin)
  9. Go to the "Modbus Configuration" section
  10. Edit the line:
    devices.carlogavazzi-em210=
    to look like this:
    devices.carlogavazzi-em210=10
  11. where "10" indicates ModBus meter adress
  12. Save & restart the modbus bridge or the DEXGate2
  13. You're done!

Click to buy! Special discounts!

Contact Us

  • Post a Public Question
  • Email Us
  • Tel : +34 931 810 195
    Hours: 9am - 6pm CEST, Mon to Fri
    support@dexmatech.com

    Check Public holidays here

    Support
soporte@dexmatech.com
http://assets1.desk.com/
false
dexma
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete