Support Center

Reports - Cost and Energy

Last Updated: Oct 16, 2013 12:32PM CEST

What is it for?

The Cost and Energy report makes a deep analysis for the most important factors in a energy efficiency project: Energy consumption and its cost. It's a double-sided report, analyzing the cost by tariff time bands, giving interesting ratios concerning average cost per kWh consumed, daily average cost, etc. 

On the second side of the report, a thermal consumption matrix is showed, for the average week, helping Energy Managers to identify major density energy consumption hours, and detect inefficiencies.  
   

Available configurations

  • Automations: Monthly or on-demand
  • By devices or groups
   

Requirements

  • Electrical, water or gas devices with data
  • Tariff assigned to each device
   

Report explanation - Side A

  1. Report title. Report gets its title from the report configuration wizard. 
  2. Date range for the report. This report is available on-demand or in a monthly automation, so each 1st day of month you will get the report. Below, it appears the report device name where data is acquired.
  3. Customer and location basic information, such as surface, location name or customer name.
  4. This chart shows the cost for the report time range, day by day, disaggregating it by tariff time bands, if necessary.
  5. Ratios concerning energy and cost for the report period. The average price per kWh is very usefull to make further analysis or to fast quantify the ROI of energy efficiency projects.
  6. Summary table for cost chart, including price, consumption and cost for each tariff band period.
  7. This charts shows the consumption for each day compared with previous period of time, in a daily frequency.
  8. Energy and power figures, such as maximum demand, total consumed energy and Utilization factor. The Utilitzation factor,in hours, divides the total consumption by the maximum demand, and explains de equivalent hours that you have been consuming at the maximum load.
  9. Summary table for energy consumption, focusing the analysis in the max and min hourly and daily consumed energy. In addition, the difference versus the previous period it's included. 
 

Report explanation - Side B

  1. Report title. Report gets its title from the report configuration wizard. 
  2. Date range for the report. This report is only available in a weekly automation, so each Monday you will get the report. Below, it appears the report device name where data is acquired.
  3. Customer and location basic information, such as surface, location name or customer name.
  4. Consumption distribution analysis, hour by hour. This analysis takes the average consumption for each hour of the week, from the weeks that take part in the report. A 24x7 matrix with the results is printed, adding global average column and row. On the right hand, a density chart is printed as an output from the average hourly matrix. This chart helps the Energy Manager to detect inneficiencies between days of week and also to know in what time ranges our facility consumes more energy. 
  5. Consumption versus cost analysis. Two different pie charts are shown in this section, for the tariff time bands distribution, focusing on energy and cost.  

Contact Us

  • Post a Public Question
  • Email Us
  • Tel : +34 931 810 195
    Hours: 9am - 6pm CEST, Mon to Fri
    support@dexmatech.com

    Check Public holidays here

    Support
support@dexma.com
http://assets0.desk.com/
false
dexma
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete